Instalacja dolotu AEM.

Start by removing the bolts that secure the intake box and intake vacuum box assembly

Remove the bolt from the rear of the airbox

Remove the (2) vacuum lines, electrical connector, and vacuum box

Remove the lower resonator attachment screw and note the intake tubing to be removed in the next step

Loosen screw-clamp, remove airbox and lower piping

Using pliers, remove clamp on breather hose

Loosen clamp and remove vacuum line

Remove intake hose and pull the breather hose loose from intake ; remove intake

Remove vacuum line (previously attached to vacuum box) and detach from throttle body. Cap with supplied vacuum cap.

This is the port to cap off. We also have the vacuum line, disconnected earlier, that we will install the filter-foam into.

AEM filter foam - trim a small section to use

Insert filter foam into hose left over from removal of intake tubing.

This is the factory opening to the lower resonator box - it will be enlarged to fit the AEM

Remove panel clip and 10mm bolt from inner fender liner

Remove 10mm bolt from underneath on lower splash panel - pull panel downward

Remove lower fender liner retaining clips. One is not visible in this picture as it is obscured by lower panel - pull back to expose lower resonator

The factory lower resonator should now be visible. Remove rear bolt

Remove front bolt and remove lower resonator assembly.

Cut hole with suitable cutting device (tin snips. hole saw, pneumatic nibbler) You can trim out the hole with a piece of slit vacuum tubing

Install AEM rubber isolator mount

Instal lhose clamp and coupler to throttle body; leave loose.

Mount the "ear" on the intake to the rubber soft mount using the washer and nut provided.

Reconnect battery-chassis ground and tighten - Check intake for clearance where it passes through the hole

Tighten hose clamps and install hose to couple the AEM intake to the stock breather pipe.

Tighten clamps on hose assembly.

Slide on air filter, install clamp and tighten;make sure to check for clearance. Replace lower splash shields

This is what it should look like when done.